组合临界流文丘里喷嘴空气流量测量方法高空舱应用分析

为满足发动机高空试验低流速进气条件下空气流量精确测量,减小进气导管气流附面层影响,弱化空气流量测量与被试发动机相关性。分析了单件/组合临界流文丘里喷嘴的工作特性,给出了组合临界流文丘里喷嘴(ACFVN)空气流量计算方法,依据给定试验发动机和高空舱尺寸设计了临界流文丘里喷嘴组合结构,得到了组合临界流文丘里喷嘴在高空舱应用的控制方法和测试布局。采用小尺寸喷嘴对组合喷嘴设计和应用方法进行了验证,结果表明:采用打开/关闭喷嘴数量和调节进气压力两种组合方式在高空舱内应用方法可行,测试布局满足测量要求,下游发动机进口截面气流紊流度优于0.3%,满足发动机高空模拟试验要求。      

表贴式永磁同步电机直接转矩控制变幅值预测控制研究

基于以电压矢量幅值为变量的表贴式永磁同步电机(SPMSM)磁链和转矩方程,采用预测控制计算得出施加不同电压矢量幅值的下一时刻磁链和转矩值,选择使磁链和转矩误差目标函数最小的电压矢量幅值作为最优值,从而确定下一时刻施加的电压矢量。仿真结果表明:在电压矢量变幅值预测下,SPMSM直接转矩控制(DTC)系统运行良好,定子磁链轨迹为理想圆,磁链和转矩均符合控制要求,转速跟踪良好,定子电流波形正弦。预测控制需要从备选电压矢量幅值集合中选择最优幅值。理论上,备选电压矢量幅值个数越多,系统优化效果越好,但也带来更大的计算负担。研究了9种等分电压矢量情况下变幅值预测控制系统的控制效果。根据控制效果和计算负担,提出变幅值预测控制将电压矢量幅值三等分较为理想。     

利用增量相位和星光仰角增强XNAV

针对X射线脉冲星导航系统(XNAV)中过程噪声统计特性难以准确获取，对其不当假设导致滤波器估计性能不佳的问题，提出基于自适应差分卡尔曼滤波器(ADDF)的多信息融合算法。为了降低导航误差，在传统脉冲星计时观测的基础上，增加恒星星光仰角及两个时刻间的相位增量观测量，共同增强XNAV。首先，分别建立计时观测模型、相位增量模型及星光仰角模型；然后将多信息测量模型集成到卫星轨道动力学方程中，以建立ADDF滤波模型；最后对所提方法进行仿真验证。实验结果表明，在相同的初始状态和初始噪声误差条件下，与传统X射线脉冲星导航算法相比，多信息融合算法能将导航位置估计精度提高70%以上，位置估计误差降低到 200 m 左右，速度估计精度提高40%以上，且ADDF性能优于无迹卡尔曼滤波器。     

Effects of yaw-roll coupling ratio on lateral-directional aerodynamic characteristics

Experimental investigation of large amplitude yaw-roll coupled oscillations was conducted in a low-speed wind tunnel using an aircraft configuration model. A special test rig was designed and constructed to provide different coupled motions from low to high angles of attack.A parameter ‘‘coupling ratio" was introduced to indicate the extent of yaw-roll coupling. At each pitch angle, seven coupling ratios were designed to study the yaw-roll coupling effects on the lateraldirectional aerodynamic characteristics systematically. At high angles of attack, the damping characteristics of yawing and rolling moments drastically varied with coupling ratios. In the coupled motions with the rotation taking place about the wind axis, the lateral-directional aerodynamic moments exhibited unsteady characteristics and were different from the ‘‘quasi-steady" results of the rotary balance tests. The calculated results of the traditional aerodynamic derivative method were also compared with the experimental data. At low and very high angles of attack, the aerodynamic derivative method was applicative. However, within a wide range of angles of attack, the calculated results of aerodynamic derivative method were inconsistent with the experimental data, due to the drastic changes of damping characteristics of lateral-directional aerodynamic moments with yaw-roll coupling ratios.     

平台式重力仪航空重力测量数据后处理技术研究

针对航空重力测量对数据后处理的要求,结合平台式重力仪系统的组成与工作原理,在重力异常信号的频域特征基础上,设计出一套有严格频域规范的航空重力数据后处理流程,并对某海域实测数据进行了处理。结果表明,重力异常值内符合精度为12条东西测线达到0.43mGal/140s和0.84mGal/100s,4条南北测线达到0.39mGal/140s和0.79mGal/100s;以同测线GT-2A单次测量结果为标准值统计标准差,12条东西测线为0.72mGal/140s和0.98mGal/100s,4条南北测线为1.41mGal/140s和1.53mGal/100s。结果表明,设计的航空重力测量数据后处理方法可以实现重力异常信号的高精度提取。     

Design and analysis of a truss deployable antenna mechanism based on a 3UU-3URU unit

Space deployable structures with large calibers, high accuracy, and large folding ratios are indispensable equipment in the aerospace field. Given that the single-DOF 3RR-3RRR deployable unit cannot be fully folded, this study proposes a 3UU-3URU deployable unit with two kinds of DOF: folding movement and orientation adjustment. First, based on the G-K formula, the DOF of the 3UU-3URU unit is analyzed. Then, the 3UU-3URU unit is used to construct a deployable truss antenna with a curved surface, and the DOF of the whole deployable antenna containing multiple 3UU-3URU units is calculated. The structural design of a deployable antenna with two loops is carried out with specific parameters and geometric relations. Next, a DOF simulation of a basic combination unit composed of three 3UU-3URU units is performed. Finally, a prototype of the basic combination unit is manufactured, and the DOF of the mechanism is experimentally verified.     

某飞行器推力矢量试验测力装置研制

为满足某飞行器推力矢量试验的测试要求,采用两台六分量应变天平和一个空气桥组成测力装置来实现飞机全机气动力和喷管推进特性同时分别测量。基于有限元软件,对天平的应变及空气桥对天平的干扰进行了分析。结果表明:空气桥对天平力分量的干扰值优于5%,对力矩(滚转力矩除外)分量的干扰值优于15%,达到了设计指标。通过校准获得了单独天平、天平带空气桥(充压、不充压)状态下的校准公式,校准结果表明:两台天平各分量的综合加载误差均优于0.3%,天平带空气桥(充压、不充压)状态下各分量的综合加载误差优于0.5%,空气桥对天平的干扰量值与有限元分析结果一致。理论分析与实测结果证明:研制的天平及空气桥达到了预定目标,它的测量精准度高,满足推力矢量风洞试验需求。     

基于任务的微机电惯性系统规模化测试技术研究

针对传统惯性测试技术测试周期长、测试效率低、测试成本高等问题，提出了基于任务的微机电惯性系统规模化测试解决方案。研究分析了微机电惯性系统测试技术的研究现状和发展趋势，建立了基于任务的微机电惯性系统测试体系，详细论证了微机电惯性系统批量、并行、自动化测试解决方案的可行性，为微机电惯性系统规模化测试实践奠定了基础。     

月球表层采样样品智能确认方法

表层采样是月球采样探测的重要方式，样品智能确认有助于提升工作效率与复杂问题处理能力。结合月球表层采样铲挖工作过程，分析了铲挖过程中臂载相机图像的特点，模仿有人参与识别过程，提出了层次解耦的月球样品智能识别流程，利用深度学习方法构建了一类深度卷积识别网络，完整地描述了图像、特征、标记在网络中的正反传递关系，并在月球表层采样地面试验中进行了验证，结果表明该方法对不同光照、不同背景、不同过程、不同形态的样品，具有较好的泛化识别能力，误识别率优于8.1%，平均单幅识别时间约0.7 s。     

Numerical investigation of flow mechanisms of tandem impeller inside a centrifugal compressor

This study numerically investigated a single stage centrifugal compressor ‘‘Radiver’’ with a wedge diffuser and several tandem-designed impellers to explore the flow phenomena within the tandem impeller and the potential to enhance compressor performance. The results demonstrate that tandem design and clocking fraction (λ_s) significantly affects the compressor performance. The compressor stage with tandem impellers of Series A of boundary layer growth interruption alone are observed to have a widely operating range but efficiency and total pressure ratio penalty compared with that of conventional impeller. The tandem impeller with at least the same impeller efficiency as the conventional design is considered as a critical design criteria so that further modification process based on the flow characteristic of tandem impeller is necessary. In order to restrain the inducer wake and exducer shock losses, parameters modification of blade angle and thickness distributions are necessary and the modified tandem impeller of Series B is obtained. The modified tandem impeller with 25% clocking arrangement shows an 8.45% stall margin increase and maintains the total pressure ratio and efficiency as the conventional design, which proves the potential of tandem impeller to improve compressor stage performance. It is noteworthy that the tandem impellers of Radiver have not shown obviously balanced exit flow field and the fundamental mechanism of stall margin extending of tandem impeller lies on the improved impeller/diffuser matching performance resulting from the incidence angle variation at diffuser inlet.